How to Build a Cat 5 Cable - Networks Article

By:Joe Hamilton

STEP 1 - Stripping

Start by pulling out about 12 feet of bulk network cable to making the process a little easier. Carefully remove the outer jacket of the cable exposing about 1 1/4" of the twisted pairs. Be careful when stripping the jacket as to not nick or cut the internal wiring. After removing the outer case you will notice 8 wires twisted in pairs and a rip cord (white thread).

STEP 2 - Inspecting

Inspect the newly revealed wires for any cuts or scrapes that expose the copper wire inside. If you have breached the protective sheath of any wire you will need to cut the entire segment of wires off and start over at step one. Exposed copper wire will lead to cross-talk, poor performance or no connectivity at all. It is important that the jacket for all network cables remains intact.

STEP 3 - Preparation

To prepare the wires and to make them easier to work with, you can untwist the pairs so they will lay flat between your fingers. The white piece of thread can be cut off even with the jacket and disposed.

STEP 4 - Layout

Now based on the wiring specifications you are following you will need arrange the wires in a certain pattern. There are two methods set by the TIA, 568A and 568B. 568B is the most common network cables, widely used for computer networks and digital phone systems. So for our demonstration we will use that. Starting from the left-top side of the RJ-45 plug, the wiring should be in the order shown at the right.

STEP 5 - Jack Preparation

Again, press all the wires flat between your thumb and forefinger as shown in step three. Verify the colors have remained in the correct order. Using a pair of scissors, cut the top of the wires even with one another so that they are 1/2" long from the base of the jacket. Ensure that the cut leaves the wires even and clean; failure to do so may cause the wire not to make contact inside the jack.

STEP 6 - Wire Insertion

Ensuring that the wires remain flat and in order, push them into the RJ-45 plug with the flat surface of the plug on top. The white / orange wire should be on the left looking down at the jack. You can tell if all the wires made it into the jack and maintain their positions by looking head-on at the plug. You should be able to see a wire located in each hole, as seen at the bottom right. You may have to use a little effort to push the pairs firmly into the plug. The cabling jacket should also enter the rear of the jack about 3/16" to help secure the cable once the plug is crimped.

STEP 7 - Crimping

Now place the wired plug into the crimping tool. Give the handle a firm squeeze, you should hear a ratcheting noise as you continue. Once you have completed the crimp, the handle will reset to the open position.

STEP 8 - Testing

Once your new cable is completed, it is not a bad idea to test the cable to ensure that it will function in the field. It is vital that all eight wires have connectivity and are in the correct order. Mis-wired network cables could lead to headaches down the road. In addition, with power-over-ethernet making its way into the market place, crossed wire pairs could lead to physical damage of computers or phone system equipment; making it even more crucial that the pairs are in the correct order. A simple cable tester can quickly verify that information for you.

You can find these instructions with pictures Here

Digg del.icio.us Blink Stumble Spurl Reddit Netscape Furl

Article keywords: Cat 5 Cable, How to build a Cat 5 cable, cat5, ethernet cable, build a cable

Article Source: http://www.articles2k.com

Comtrad Cable

Top Networks Articles
1). Router - Denial Of Service Attacks By : Michael Russell Routers are not perfect. For that matter, nothing is. So if somebody wants to give a router more than it can handle there is a way to do this. We're going to take a look at what are called denial of service attacks. A router can only handle so much information coming into it at one time. Every machine has its limits and routers are no exceptions. Well, when the nasty trend of denial of service attacks started early this century, routers were unprepared for them.
2). Fiber Optics In The Real World By : James Croydon Optic fibers are used widely in the medical field for diagnosing and treating a variety of ailments. Because optic fibers can be made extremely thin and made into flexible strands, they can be used for insertion into blood vessels, lungs and other parts of the body. Optic fibers have been enabling physicians to look and work inside the body through tiny incisions with an instrument called an Endoscope.
3). Six Largest Mistakes Made when Hiring a Cabling Contractor By : Robert Deupree Cabling of data and voice systems is often ignored by many companies until the last minute just before relocation or new building takes place. Many information systems professionals view it as a low priority or something that just takes away from their budget for real network components such as servers or software. However having a state of the art easy to manage cabling system is just as important as good reliable servers on a network.
4). Computer Networking Fundamentals By : Susan Jan Computer network is an integral part of our daily lives, with the most important reason being that of communication.
5). Ethernet - explained By : john Do you use Ethernet? You might think that you don’t, but don’t be so sure. Ethernet is everywhere – if you use a networked computer, whether it’s at home or in your office, you’re using Ethernet. Ethernet is two things: a kind of cable for connecting computers together, and the method of communication that the computers use over the cables. Essentially, it is the glue that holds LANs (local area networks) together.
6). Defense Pro by Radware - the Best Computer Defense Available By : Ariel R As the popular saying goes; the best defense is a good offense, so too can it be applied to computer security. To safely secure a computer network a passive firewall is no longer enough. Hackers have learned and adapted their tactics to bypass firewalls and antivirus software. What is needed to defend your computer network is an active and intelligent monitor and defender.
7). Home Wireless Networks Are More Popular Than Ever By : George Royal It is now very simple to set up home wireless networks. Wireless networks are very popular and are found in many places such as cafes and other public areas. There are no actual cables and the set up is very minimal. With the boom in this technology and an increase in the manufacture of this technology this has resulted in a decrease in the cost of setting up wireless networks and made them available to the typical user.
8). Crime Fighting Computer Systems and Databases By : Sam Vaknin As crime globalizes, so does crime fighting. Mobsters, serial killers, and terrorists cross state lines and borders effortlessly, making use of the latest advances in mass media, public transportation, telecommunications, and computer networks. The police - there are 16,000 law enforcement agencies in the Unites States alone - is never very far behind.
9). Router - Transmitting Packets By : Michael Russell In a previous article we discussed the basics of what a router did. We're now going to get into a more detailed, and yes technical, explanation of how packets are transmitted as well as a few other tech specs of how routers work. So put on your learning caps because you're in for a real mind bender. Internet data, whether it be in the form of a web page, a downloaded file or an email message, travels over what is called a packet switching network.
10). There’s no mystery in the IP address! By : Gamit Ana The Computer is a very complicated device we use for our every day comfort and the importance of some of its numerical aspects is sometimes neglected. For example: a different number is given to each computer when its user goes online or when it is part of a network. This number is the IP address and knowing about it is like knowing where you live… What’s my IP and what do its numbers stand for? IP stands for Internet Protocol and the address is formed from 4 numbers separated by periods.

New Networks Articles
1). How to Build a Cat 5 Cable By : Joe Hamilton STEP 1 - Stripping Start by pulling out about 12 feet of bulk network cable to making the process a little easier. Carefully remove the outer jacket of the cable exposing about 1 1/4" of the twisted pairs. Be careful when stripping the jacket as to not nick or cut the internal wiring. After removing the outer case you will notice 8 wires twisted in pairs and a rip cord (white thread).
2). Network Security – The Real Vulnerabilities By : Dennis dEntremont Scenario: You work in a corporate environment in which you are, at least partially, responsible for network security. You have implemented a firewall, virus and spyware protection, and your computers are all up to date with patches and security fixes. You sit there and think about the lovely job you have done to make sure that you will not be hacked.
3). Small Business Networking: Suggesting Dedicated Servers to Clients By : Joshua Feinberg PC-based servers and LANs may be relatively mature technologies. However, small businesses need your firm’s expertise, more than ever. For these businesses, you'll need to select, configure, customize, secure and maintain the right small business networking tools for their unique needs. Real Small Business Networking Solutions Begin with Real Servers How.
4). Network Cabling: Available Options By : Joshua Feinberg As their IT consultant, your small business prospects and clients will need you to explain the different network cabling options available to them. Traditional Wired Ethernet (Category 5) Until very recently, Category 5 data cabling was the de facto standard for both enterprise and small business LANs. Today, you’ll find some enhancements available to Category 5 cabling, as well as booming interest in wireless Ethernet solutions.
5). Recognize And Understand Home Networking Components By : Otis Cooper If you have not decided already,you will soon want to network your two or more computers in your home. You want to be armed to the teach with knowledge of just what it takes to connect your computers to one another. You first should decide which network is best your you. If your computers are in the same room,the Wireless network should not be considered.
6). The Simplest Way to Get Online Passive Income By : Isulong SEOPH Based on my research, this seems to be the basic principle that website owners have been following to get passive income online: * Get many people to come to your website * Get them to click on your Adsense links Sounds simple enough. Get people into your website from Google search, then link out to an Adsense Ad. Search In – Adsense Out. Practically applying it to get sufficient commendable income, however, can be quite a challenge.
7). What is search engine gateway? By : Tony Zhou Navino launched its search engine gateway service recently. For most of the Internet surfers, search engine gateway is a pretty new concept compared with meta search engine or multi search engine. Put it in simple, it is a web service, which can let you search the best information from the best content providers in one website. When we try to find information everyday, most of us might go to Google.
8). 5 Steps to Securing Your Windows XP Home Computer By : Richard Rogers Most people are aware that there are continuous security issues with Microsoft’s Windows operating system and other programs. However, what most people do not realize is how easy it is to significantly improve your computer’s security and reduce the likelihood of becoming a victim to ever increasingly sophisticated threats that lurk on the internet.
9). RFID, its implications and how to defeat By : Jon Winthrop Imagine a future in which your every belonging is marked with a unique number identifiable with the swipe of a scanner, where the location of your car is always pinpoint-able and where signal-emitting microchips storing personal information are implanted beneath your skin or embedded in your inner organs. This is the possible future of radio frequency.
10). IT Networking: Cost-Savings, Productivity and Security By : Joshua Feinberg By engaging small business decision makers in discussions about their IT networking needs, you can highlight how automating services like faxing will save your prospect’s or client’s company on manual labor, which indirectly translates into substantial salary savings over the course of the year. At the very least, network-based faxing will free up staff to focus on higher-level activities, rather than "babysitting" an archaic fax machine.